Dougherty County · Elsewhere in Georgia
Concrete contractors in Albany, GA
Driveways, patios, slabs, stamped concrete and repairs in Albany. We come out, measure and leave you a free written estimate, then pour it on a date we agree with you.
Concrete work we do in Albany
- Concrete drivewaysWe pour new driveways, replace cracked and heaving ones, and extend driveways that are too tight for a second car, on a compacted base with the joints and finish done right.
- Concrete patiosFrom a simple pad for the grill to a full outdoor living area with steps, borders and a fire-pit pad, we pour patios that drain away from the house and look good for decades.
- Concrete slabs and foundationsConcrete slab contractors for garages, workshops, sheds, carports, hot tubs and additions, and concrete foundation contractors for slab foundations (monolithic and stem-wall) on new construction, poured to the plan and ready for inspection.
- Stamped and decorative concreteStamped patterns, integral color, exposed aggregate and borders for patios, driveways, pool decks and walkways: the look of stone or pavers in one solid slab.
- Walkways, sidewalks and stepsFront walks, side paths, pool surrounds, public sidewalk sections and poured steps, plain or finished to match the patio.
- Concrete repair and resurfacingCrack repair, slab lifting, resurfacing overlays and partial replacement for driveways, walks, patios and garage floors. We tell you honestly whether a repair will hold or the slab needs to go.
- Concrete retaining wallsPoured concrete and reinforced block retaining walls for slopes, driveways cut into a hill, raised patios and garden terraces, with the footing and drainage that keep them standing.
- Commercial concreteParking lots, loading areas, dumpster pads, sidewalks, curb and gutter, slabs and ADA ramps for businesses, HOAs, churches and property managers, scheduled around your operation.
Pouring concrete in Albany
Albany is a city of about 69,647 people in Dougherty County. Most of what we pour here is driveways (new, replacement and extensions), patios and backyard slabs, with repairs and stamped work close behind. Our crews cover Albany and the rest of Dougherty County, so the estimate visit and the pour are scheduled locally, not from across the state.
Water, soil and the ground under the slab
Before we price a job in Albany we look at where water goes today: downspouts that discharge onto the slab area, low corners that hold a puddle, edges that have washed out, and any old concrete that has already settled or heaved. Most of Georgia sits on clay that swells when wet and shrinks when dry, so the fix is in the preparation, not the mix: a compacted gravel base, a slope that sends water away from the house and the neighbor's lot, reinforcement sized to the load, and control joints on a planned layout. Where the ground has moved before, we say so in the estimate and tell you if a soils or foundation specialist should look first.
Permits in Albany
A driveway apron that meets a public street, a retaining wall above a certain height and any slab that carries a building usually need a permit from the City of Albany or Dougherty County. Rules differ from one Georgia jurisdiction to the next. We tell you at the estimate which permits apply to your job, and pulling them is part of the work, not an extra you have to chase.
Concrete prices in Albany
We don't publish Albany-specific prices, and we don't invent them: the price for concrete work in Albany depends on your site, so we measure first. Our cost guides give national ranges from cited sources: about $5 to $8 per square foot for a plain driveway or patio, $10 to $20 and up for stamped concrete, and $10.63 to $13.00 for a basic installed slab. Size your project with the concrete calculator, then compare our written estimate line by line against those ranges.
Concrete conditions in Albany
Averages from the nearest NOAA climate normals station, Albany Sw Ga Rgnl AP, GA (3.1 miles away, 190 ft), over 1991–2020.[1] Conditions can change over short distances, so treat these as a planning guide, not a forecast.
- Nights at 32°F or below
- 28
- Days at 90°F or above
- 106
- Precipitation a year
- 47 in
- Average temperature
- 68°F
Heat and drying
Heat is the main scheduling issue: about 106 days a year reach 90°F, 72 of them in June–August. NRMCA's hot-weather guidance is to avoid placing and finishing during the hottest part of the day, never to sprinkle water on the slab to ease finishing, and to use sunscreens, windbreaks, fogging or evaporation retarders when it is dry and windy, because fast evaporation causes plastic shrinkage cracks. We order a set-retarding admixture when the day calls for it and start early.[4]
Cold and freeze-thaw
Freezing nights are a regular part of winter in Albany, about 24 of them in December–February, but rare outside it. A pour between late fall and early spring may need the cold-weather precautions ACI describes for air temperatures expected below 40°F. For driveways, walks and patios that freeze while wet, NRMCA recommends air-entrained concrete to resist scaling. Our estimates say whether the mix is air-entrained.[2, 3]
With 47 inches of precipitation a year, we plan how fresh concrete gets covered if rain arrives during or soon after the pour, and slope the finished slab to shed water away from the house.
Planning guides: pouring in summer heat · pouring in cold weather · curing times · driveway thickness
- NOAA National Centers for Environmental Information, U.S. Climate Normals 1991–2020 (annual and seasonal, by station) (archive c20230404; imported November 6, 2026), station USW00013869.
- American Concrete Institute, ACI 306R-16: Guide to Cold Weather Concreting (preview) (2016 edition; checked October 6, 2026).
- National Ready Mixed Concrete Association, CIP 2: Scaling Concrete Surfaces (checked October 30, 2026).
- National Ready Mixed Concrete Association, CIP 12: Hot Weather Concreting (checked October 30, 2026).
What to have ready for your Albany estimate
None of it is required to send the request. It just makes the callback shorter and the estimate more accurate.
- The property address, so we can check the permit office and get the right crew
- Rough dimensions: pace it out, or size it with our concrete calculator
- What it's for: cars, a work truck, a hot tub, a shed, foot traffic
- A couple of photos of the area and the route a concrete truck would take
- Anything you've noticed about water: puddles, a downspout, a low corner
- When you'd like it done
Questions from Albany homeowners
How do I get a concrete estimate in Albany?
+
Fill in the form on this page with the type of project, your ZIP code, rough size and timing. We call to schedule, then come out to Albany, measure and leave you a written, itemized estimate. It's free.
Do you pull permits in Albany?
+
Yes. Driveway aprons, retaining walls above a certain height and structural slabs usually need a permit from the City of Albany or Dougherty County. We tell you which apply to your job and handle them.
What does a concrete driveway cost in Albany?
+
We don't publish Albany-specific prices. Nationally, plain concrete driveways run about $5 to $8 per square foot installed and decorative finishes $8 to $21 (ConcreteNetwork, 2026). Your written estimate, with tear-out, base and finish itemized, is the real number.
How soon can you pour in Albany?
+
Estimates usually happen within a few days of your request. The pour date depends on the season and the schedule; we agree it with you when you accept the estimate, and we plan it around the weather.
Why homeowners choose us
A written estimate you can compare
Thickness, base depth, reinforcement and finish are spelled out line by line, so you can hold any other quote against it.
One call, then a date
We call back to confirm the details, usually the same business day, and book the visit at a time that suits you. No chasing.
Insured crews, permits pulled
General liability insurance on every job, the certificate with your estimate, and we pull the permits your city or county requires.